Freeze in cisterns - Printable Version +- Frictional Games Forum (read-only) (https://www.frictionalgames.com/forum) +-- Forum: Technical Support (https://www.frictionalgames.com/forum/forum-57.html) +--- Forum: Technical Support - Amnesia: The Dark Descent (https://www.frictionalgames.com/forum/forum-31.html) +---- Forum: Mac - ATDD (https://www.frictionalgames.com/forum/forum-33.html) +---- Thread: Freeze in cisterns (/thread-4695.html) |
Freeze in cisterns - henrik - 09-23-2010 Hi, I'm experiencing constant freezes in the cistern area (it's happened both in the western sewers & in the control room areas). The game simply freezes with graphics distortions all over the screen, and a snippet of the sound continuously playing for a while (but stops after a couple of seconds). I can't do anything with the computer, and have to force it off with the power button. Until I reached this area I haven't had any problems with Amnesia, and I haven't experienced any freezes before on this computer. I'm playing on a 15" 2010 MacBook Pro & my hardware info is: Modellnamn: MacBook Pro Modellidentifierare: MacBookPro6,2 Processornamn: Intel Core i7 Processorhastighet: 2,66 GHz Antal processorer: 1 Totalt antal kärnor: 2 L2-cache (per kärna): 256 K L3-cache: 4 MB Minne: 4 GB Anslutningshastighet mellan processorer: 4.8 GT/s Boot ROM-version: MBP61.0057.B0C SMC-version (system): 1.58f15 I've attached the game log from the last session, but I don't think it contains anything related to the freeze.. Any ideas? //H RE: Freeze in cisterns - Urkle - 09-23-2010 can you send me the save game file and what you did to recreate the crash? Also, is your laptop overheating at all? RE: Freeze in cisterns - henrik - 09-23-2010 (09-23-2010, 02:00 PM)Urkle Wrote: can you send me the save game file and what you did to recreate the crash? I've attached the save game the log says it loaded. I didn't do anything in particular to recreate the crash; just walking around solving the puzzles in the area. The fans were working quite a bit, but that's only natural when running a 3D game. One of the times it froze, the computer casing was quite hot (that's also pretty common for a i7 MBP), but when the last freeze occured I hadn't been playing for long (just a few minutes), so the computer didn't feel warm at all. It was on a flat surface & the vents were not covered in any way. I don't have any fan or temperature surveillance installed on this computer, so I can't give you any exact information on the heat status inside the case though. Ah, the save-file was to large to attach.. It can be downloaded here instead: http://cl.ly/401213e392d9439e6533 //H I installed SMC Fan Control to keep track of the temperature, and switched to running in windowed mode (I've always played in fullscreen before) to see the menu bar with fan info. Otherwise I kept the same settings, but increased from Medium detail level to High (I had lowered to Medium before to see if that helped against the freezes, which it didn't). I experienced no freeze, and the temperature kept between 65-85° Celsius, with one peak in the beginning of about 98°, which triggered the fans to go up to around 5000-6000 rpm for the rest of the session (and kept the temperature down). I did however manage to make Amnesia crash by playing for a while and then trying to load the saved game I've linked above. After restarting, I could load the game without any problems though.. |