Issue regarding custom models

[Quietus]

Odd that the OpenCollada exporter doesn't work, I do not remember wheter the installation was causing a fuzz or not at the time I was installing it. See if you can find a way to make it working (I may have had to search for a solution but I'm not quite sure - it was about a year ago).

As for temporarily fixing your issue have you tried making a compound of the walls? Aligning two of them and then pressing B should center the pivot point and allow for easier future placement.

I have found that model exporting to Amnesia is best suited using the OpenCollada plugin, while the FBX export may cause issues.

The issue with OpenCollada is with the installation wizard. If it doesn't recognise Maya as installed on the hard drive it skips the installation. I read somewhere that someone got round this issue by installing it manually, but i don't have the technically know how of doing this. In the end using FBX seemed to solve the problem and except the issue regarding the pivot, it seems to work without too much trouble.

Cheers for the suggestions =]. It helps when aligning large groups of them together! I also found a solution with using the numbers in the general tab of the static mesh instead of using the handles. I really should have thought of that earlier haha xD

Thanks again! =]