Facebook Twitter YouTube Frictional Games | Forum | Privacy Policy | Dev Blog | Dev Wiki | Support | Gametee


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Spoiler Stuck in machine room please help
Romulator Offline
Not Tech Support ;-)

Posts: 3,628
Threads: 63
Joined: Jan 2013
Reputation: 195
#3
RE: Stuck in machine room please help

Spoiler below!

The Amnesia Wikia Wrote:To activate the machinery you have to: stabilize the steam pressure, insert the rods in the right holes, fill the burner with coal and put the cogs on their place. These operations can be done in any order.

Steam pressure: you should find yourself facing a console with six levers and roman numbers above and below them. The solution is to pull the levers that add to 8 both up and 8 down. A right configuration can be: first, second and sixth Down and the others (third, fourth and fifth) UP. The solution is hinted in the note "Elevator Machine Instructions". (Left to right, NOT Roman numbers)

Rods: the console has three holes and "Tractatio Fluxus" written above. The Flow Cycle Rod fits into the circle hole, the Trinity Stream Rod in the triangle one and the Four-phase Amplitude Rod in the square hole.

Powering the machine: first you must fill the burner with coal. The burner is on the left on the machine and the coal is stashed in an adjacent room. Three chunks will do the job. Once filled, a message will pop up, then pull the lever on the left of the burner. Now you must find three cog wheels and put them on the poles, right from the burner. One wheel is found in the rods room, on a small table in the corner, at the right of the console. The second one is right in front of the door of the rods room. The last one is in the machinery room, at the entry door's left. Just lift each wheel and bring it on the empty spots and they will fit in automatically. Now you just have to pull the lever and the machinery will start to work.Once completed all the tasks the Shadow will invade this section of the castle.


Discord: Romulator#0001
[Image: 3f6f01a904.png]
(This post was last modified: 05-26-2013, 02:14 PM by Romulator.)
05-26-2013, 02:13 PM
Find


Messages In This Thread
Stuck in machine room please help - by aohxomen - 05-26-2013, 01:58 PM
RE: Stuck in machine room please help - by Romulator - 05-26-2013, 02:13 PM



Users browsing this thread: 3 Guest(s)