Animations

[Rapture]

If you want to move the model along the X/Y/Z axises. You can change the model into a "MoveObject" in the ModelEditor>Settings>User Defined Variables.

(1) So open up 2 separate ModelEditors, in one, open up the Amnesia Piston (Entities>special>control_room_piston_piston). In the second open up your model.

(2) Open up the Menu>Settings>User Defined Variables. And match up your model's properties with Amnesia's Pistons, and save it out.

Use

Code: (Select All)

SetMoveObjectState(string& asName, float afState);

Code: (Select All)

asName - internal name
afState - state of the object, 0 = closed, 1 = open, values inbetween (and above, for example, the bridge_metal_vert) are valid too!

or

Code: (Select All)

SetMoveObjectStateExt(string& asName, float afState, float afAcc, float afMaxSpeed, float afSlowdownDist, bool abResetSpeed);

Code: (Select All)

asName - internal name
afState - state of the object, 0 = closed, 1 = open, values inbetween are valid too!
afAcc - acceleration
afMaxSpeed - maximum speed
afSlowdownDist - Distance to the target state before decceleration occurs.
abResetSpeed - Set to True if the prop's speed should be reset before performing the movement, else the prop will accelerate from it's current speed to afMaxSpeed.

to move your new object.

////////////////
If you want to change the distance the object goes in a certain direction, or the Axis it travels on.

Go back to your User Defined Variables in the ModelEditor and scroll down.

Near the bottom starting with "OpenAmount" and ending with "CloseSpeed". Will be the variables you will want to change.

Note: The "OpenAmount" correlates to the height of the object. If you double the "OpenAmount", the height will simple increase 2x.

So I would set the "OpenAmount" to something like 10, and then use the MoveObject scripts and set the "float afState" anywhere between 0-1, and since it's a float you can fine tune the value of movement.