bagmanpt
Junior Member
Posts: 9
Threads: 4
Joined: Mar 2012
Reputation:
0
|
Creating a Crank type item.
Hi there
another question regarding custom models.
I made a model, with parts.
one i want it to rotate and the other to stay still. Just like a crank works on the original amnesia.
here is how its set:
Still part:
body attached to joint as parent, and mass 0
Rotating part:
body attached to joint as children, and mass 2.
everything works good except with the part of when i turn the rotating part, the still part will rotate aswell.
i thought it was because the parts were intersecting, but after modeling them and make sure they're not going to connect, it does the same thing. any one can give me a hand here?
i believe its a simple thing but i just havent seen the problem yet.
thank you in advance
SOLVED IT!
sorry, after looking into it further, i've noticed that i needed to attach the still body to a sub mesh. i hope that if anyone had the same problem that this post would help.
(This post was last modified: 04-05-2012, 06:58 AM by bagmanpt.)
|
|
04-05-2012, 06:29 AM |
|